Getting the mix right in your foamer is one of the simplest ways to improve cleaning results and control cost per wash.

In this short video, we walk through how to correctly mix FlowRPM chemicals in a foamer, using the dilution chart and following a simple, repeatable process.   If you’ve ever second-guessed your ratios or wondered whether you’re getting the most out of your chemical, this will clear it up.

Step-by-Step Overview

The video covers:

• Checking the recommended dilution rate for the chemical
• Filling the foamer with the correct amount of water first
• Measuring and adding the required amount of FlowRPM chemical
• Securing the lid and ensuring the unit is sealed correctly
• Pressurising and applying foam evenly to the surface

You’ll also see how to adjust your approach depending on the level of contamination and the type of cleaning task.

Download the FlowRPM Dilution Chart for PA and Suttner Foamers here

A Simple Rule 

Always start with water, then add chemical. This helps achieve proper mixing and reduces the chance of excessive foaming during filling. 

Apply, Dwell, Rinse 

Once applied, allow the foam to dwell and do the work before rinsing. Chemical needs time to break down contamination properly. Rushing this stage often leads to using more pressure than necessary. 

Confidence in the Setup

Using the dilution chart alongside this mixing method gives you a repeatable system.  Watch the full video to see the complete process in action and make sure your next mix is spot on.